PORTRAIT- Load paper into plotter and press any key (Drawing map--press <Escape> to interrupt0Sending map to file--press <Escape> to interrupt3Sending map to printer--press <Escape> to interrupt2Disk error. (Probably drive open or out of space.)
Printing interrupted.
Could not find driver
EPIMAP
PRINT file specification
Print file name:
&Overwrite existing file with same name( Initializing printer - Mode
S COM port
does not respond properly.U
N/A
N/A U
N/A U
2
-Save setup file
-Continue
-Show list
changes optionU
BND file directory:
Data/Map directory:
BGI file path:
XXXX Baud rate
XXXXX
Parity
Default modeU
Epi Map Setup
Default Paths
Printer Setup
Printer #1
Printer #2 DigitizerU
% Setup file written. Press any key.
Error writing setup file.U
: V f p ~
REGIONS
Mapfile does not exist.
Loading boundary file
Loading data file1Choose the variable containing the boundary names
Boundary Variable$Choose the data variable for mapping
Data Variable
Loading annotationsU
!Disk full while writing map file.
Error writing map file.U
REGIONS
LIST
+="Epi Map Version 1.0 Map Description File"
& M o
7 < s
!.!3!J!O!g!l!
"$")"c"
"*#/#
$"$^$k$p$
$'%,%F%Q%p%u%
&D&I&|&
'''C'_'d'o'y'
'5(Q(V(p(u(
)0)=)K)V)[)`)
*G*T*f*q*v*
+H+S+^+
,@,K,j,o,
-&-=-H-_-d-
f&;E||
&:E t
Region:
Edit!
Select!
Delete!
Combine!
Move! Utilities
Edit boundary names..
Configure digitizer..
eXit!U
#bnd:
Name:
#poly:
#vert:
F2 Add island F5 Divide region
F6 Zoom on
selected
F7 Zoom larger
F8 Zoom
smaller F9 Common
boundary
Esc Done
----U
DPosition cursor at one end of subdivision boundary and press <Enter>FPosition cursor at other end of subdivision boundary and press <Enter><<Enter> or click to draw point. <F4> on last point to close.:Move cursor to second corner of zoom box and press <Enter>6Put cursor on corner of area to zoom and press <Enter>4Select/unselect regions with <Enter> or mouse click.6Use F5 for rectangular selection, F6 to select by name=Position cursor on corner of selection box and press <Enter>.@Move cursor to second corner of selection box and press <Enter>./Press <Enter> to begin moving selected regions.(Press <Enter> after positioning regions.=Move pen to lower left corner of digitizer and press <Enter>.>Move pen to upper right corner of digitizer and press <Enter>.+Press <Enter> or click on area to be edited5Then <Enter> on highlight, drag, release with <Enter>.<F2> to Add Islands, <F9> for Common Boundary.;Position cursor at start of common border and press <Enter>9Position cursor at end of common border and press <Enter>@Press <Enter> to accept border, <Esc> to abandon, space to cycleU
Press ESC.U
&;E|}
&;E|~
*Enter a name for the new combined region:
DDo you wish to retain the borders within the combined region (Y/N)?
&;E|}$
&;E|}w
&;E|~
Enter new region name:
Please try again:
has already been used
Enter other region name: U
=Please try again: the cursor must be positioned over a vertexFPlease try again: the cursor must be over a vertex in the same polygon9The common boundary must begin and end in the same regionU